
Macalloy Compression Struts
The Macalloy Architectural Compression Strut provides an aesthetically pleasing long taper to each end of the compression strut.
The system uses the same fork end system as the Macalloy tension bar and cable systems, allowing for a successful combination of all three systems.
Available in either carbon, galvanised or stainless-steel finish, the Architectural Compression Strut comes complete with an adjustable locking collar that provides a seamless link (hiding the thread used to connect the fork) between the fork end and the strut.
Available in all major CHS (Circular Hollow Section) diameters from 33.7mm to 323.9mm. Custom
dimensions are available on request.
Features
- Can be used in compression, tension and reverse loadings.
- An architectural alternative to steelwork.
- Adjustable system, allowing for site anomalies and ease of installation.
- Circular steel creating optimum strength.
Maximum compressive capacity of strut to EN1993
1 kN
Maximum compressive capacity of fork to EN1993
1 kN
Maximum pin to pin length on EN1993 standard
1 mm

Figure:
Standard Compression Strut





Figure:
Assembly and installation
The table is not uploaded or the values for the variables: Material do not match table records.

Figure:
Fork adjustment and set-up points
The table is not uploaded or the values for the variables: do not match table records.

Figure:
CHS fork end
The table is not uploaded or the values for the variables: do not match table records.

Figure:
CHS fork dimensions
The table is not uploaded or the values for the variables: do not match table records.





Figure:
Assembly and installation

Figure:
Architectural Pin
The table is not uploaded or the values for the variables: do not match table records.

Figure:
Gusset plate
The table is not uploaded or the values for the variables: Isolation required? do not match table records.